Ingeteam RAPID 60 Manual De Instalacion Y Uso página 42

Ingeteam
7. Connection of accessories
This chapter explains the process for wiring the standard and optional accessories to the unit.
Read carefully before starting the connection process.
7.1. Safety instructions for connecting accessories
DANGER
There must not be any active charge in the charger.
The charger must not be connected to any vehicle.
Make sure there is no voltage present on the unit before starting the connection.
Lock and tagout any possible external feedback from the unit.
Mark the external power system with a Personnel Working Warning.
Open the unit using the personal protective equipment defined in this manual.
Confirm the absence of voltage in the connection to the unit.
Confirm the absence of voltage when dismounting any protection against direct contact.
CAUTION
Ingeteam accepts no liability for any damages caused by an incorrect connection.
7.2. VISA kit
Download the manual corresponding to each payment terminal from the INGETEAM EVC Training platform.
https://www.ingeteamevctraining.com/
7.3. External communication interconnection kit
This kit contains an 8-port switch which permits the interconnection of up to 8 Ingeteam charging points in an
installation.
7.3.1. Mechanical installation
The Ethernet switch must be installed on the DIN rail located at the bottom of the door in the position shown in
the figure.
42
Connection of accessories
300000772 - Monterings- och bruksanvisning