Publicidad
Idiomas disponibles
Idiomas disponibles
COMMISSIONING AND USE
To perform the initial start-up, proceed with the operations described
below:
- connect the appliance to the electrical system using the cable pro-
vided
- position the appliance's "main switch" to "I" (on)
- press the on button
on the remote control or on the control pan-
O
el fitted on the unit.
l
During the first ignition attempts, bad odours may
be released due to the evaporation of the greases
or oily liquids used to manufacture the product and
contained in the paint:
adequately ventilated the room where the appliance
■
is installed
avoid staying in the room for too long, as the vapours
■
emitted could be hazardous to people and animals
during the first few days of us, it is advisable to run
■
the appliance at high power.
8.3
INITIAL START-UP - WOOD
l
Before proceeding with the operations described be-
low, consult the chapter "Ignition".
a
Before starting-up the product:
remove any accessories that may have been sup-
■
plied or any combustible elements from the ash tray
and free the firebox from any devices used for block-
ing it during transportation
check that the brazier is positioned correctly in its
■
seat inside the combustion chamber: the flat part
must face upwards so that the ash can fall into the
tray without any difficulty
when igniting the appliance for the first time, use lit-
■
tle wood chopped into small pieces and observe the
instructions given under
NO
CS.DLA.IST_EN_Rev. 1.0_11-23
"Loading wood
fuel".
Fig. 14
l
During the first ignition attempts, bad odours may
be released due to the evaporation of the greases
or oily liquids used to manufacture the product and
contained in the paint:
adequately ventilated the room where the appliance
■
is installed
avoid staying in the room for too long, as the vapours
■
emitted could be hazardous to people and animals
moreover, during the first few days of use, the appli-
■
ance should be operated at minimum power.
The first ignition is necessary to verify that the appliance works prop-
erly but also to allow the product's body to settle and the greases or
oily liquids used to manufacture it and present in the paint to evapo-
rate fully. During the initial period it is advisable to use the product at
minimum capacity, loading the firebox for the first day with 50% fuel.
At the end of this procedure, greases or oily liquids will have evaporat-
ed, the paint will have stabilised and the product can be used normally.
If necessary, the appliance can be used at maximum capacity until the
substances that cause bad odours have disappeared entirely.
8.4
COATING AND FINISHES
To complete the appliance's installation, in addition to that described
above, it may be necessary to also install some accessories, an outer
cladding or other items and finishes.
l
In case of a standard outer cladding and accesso-
ries, follow the instructions provided with them.
l
We recommend performing the steps specified un-
der
Initial start-up -
before completing the assembly of the cladding
■
once the cladding has been completed and after all
■
the necessary building works have been consolidat-
ed.
wood:
EN
19
Publicidad
