Publicidad
Idiomas disponibles
Idiomas disponibles
EN
11.8.2 CLEANING OF THE HEAT EXCHANGER - WOOD
SIDE
To complete the cleaning of the heat exchanger:
- open the door of the appliance, consult the paragraph
door"
- pull the locking profile (1) towards you to release the top refractory
brick (2) and remove it; during the operation, support the side bricks
(3) to avoid them falling.
2
l
It is advisable to proceed with the
combustion
chamber" operation.
11.9 CLEANING OF THE COMBUSTION CHAMBER
l
Recommended cleaning frequency: consult the para-
graph
"Scheduled
maintenance".
Before proceeding with the cleaning operations, any
■
unburned pellets left in the brazier must be removed.
To dispose of any ash, consult the paragraph
■
disposal".
TOOLS TO BE USED; brush with soft bristles (NOT
■
supplied).
d
Do not use abrasive sponges or wet cloths and do
not place the refractory bricks in direct contact with
the ash suction machine's tube.
Do not use water to clean the inside of the combus-
■
tion chamber.
34
"Opening the
1
3
Fig. 40
"Cleaning of the
"Ash
11.9.1 CLEANING OF THE COMBUSTION CHAMBER -
PELLET SIDE
l
It is advisable to perform beforehand the
of the heat
exchanger" operation.
d
The unburned pellets must NOT be poured into the
tank.
To clean the combustion chamber, proceed as follows:
- open the door of the appliance, consult the paragraph
door"
- remove the flame separator
- clean the brazier –, consult the paragraph
- dust the surface of the refractory bricks gently using a brush
- remove the ash tray
- clean the ash tray, consult the paragraph
MAINTENANCE
"Cleaning
"Opening the
Fig. 41
"Cleaning of the
brazier"
"Cleaning of the ash
tray"
Fig. 42
CS.DLA.IST_EN_Rev. 1.0_11-23
Publicidad
