Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
- use a suitable ash cleaner to suck up combustion residues.
11.9.2 CLEANING OF THE COMBUSTION CHAMBER -
WOOD SIDE
l
It is advisable to perform beforehand the
of the heat
exchanger" operation.
To clean the combustion chamber, proceed as follows:
- open the door of the appliance, consult the paragraph
door"
- pull the locking profile (1) towards you to release the top refractory
brick (2) and remove it; during the operation, support the side bricks
(3) to avoid them falling.
2
CS.DLA.IST_EN_Rev. 1.0_11-23
Fig. 43
"Cleaning
"Opening the
1
3
Fig. 44
- dust the surfaces of the combustion chamber gently using a brush
- clean the brazier –, consult the paragraph
- remove the ash tray
- clean the ash tray, consult the paragraph
- use a suitable ash cleaner to suck up combustion residues.
11.10 CLEANING OF THE PELLET TANK
l
We suggest completely emptying the pellet tank at
the end of every season.
TOOLS TO BE USED; ash suction machine.
■
To completely empty and clean the pellet tank, proceed as follows:
- with the fire extinguished and the appliance completely cold, open
the door and remove all the pellets inside the tank
- switch the appliance on and leave it running until all the pellets have
finished and the appliance switches off
- wait for the appliance to cool down
- use an ash suction machine to suck up any remaining sawdust or
pellet residues on the bottom of the tank
- close the door.
EN
"Cleaning of the
brazier"
"Cleaning of the ash
tray"
Fig. 45
Fig. 46
35
Publicidad
