Keyline 994 LASER Manual De Uso Y Mantenimiento página 40

3Transport and installation
3.1.0 Packaging
Packaging includes a cardboard box with the following dimensions:
Dimensions Machine
Width 460 mm
Height 460 mm
Depth (Length) 435 mm
3.1.1 Opening the package
Remove the machine and the console from the packing materials fol-
lowing the instructions below:
Key-cutting machine
1. Remove the seals or the tape to open the package.
2. Open the box that contains the key duplicating machine.
3. Remove carton "6" that contains the case with the kit of
accessories.
4. Remove carton "5" from the box.
5. Remove carton "2" and "4" from the box.
6. Free the machine from the packaging material.
2
3 4
5
6
Console
1. Remove the seals or the tape to open the package.
2. Open the box that contains the console.
3. Free the console from the packaging material.
IMPORTANT!
We recommend you to keep the packaging during the
warranty period.
6 Keyline S.p.A.
TRANSPORT AND INSTALLATION
3.2.0 Transport
The markings on the packing materials indicate how to handle the
machine during transport.
Console
3.2.1 Unloading and handling the machine
460 mm
The machine can be unloaded manually by 2 or 3 persons, or by using
a handling equipment (for example a lift truck).
200 mm
435 mm
Avoid dropping the machine, even a small damage
could impair its correct functioning.
3.3.0 Temporary storing
If the installation of the machine does not occur immediately, store
the machine in a dry and properly ventilated place.
• Apply an appropriate coating.
• Rubber parts must be protected against too low tempera-
tures. Never store them outdoors, not even for short peri-
ods.
If the machine is stored or remains unused for long pe-
riods or if it is started a long time after delivery, gaskets
or retaining rings may undergo hardening thus causing
leaks or seizures.
2
3.3.1 Characteristics of the place of installation
The key cutting machine must be placed on a smooth level bench
3 4
about 90 - 110 cm (35 - 43 Inches) high, suitable for bearing the weight
of the machine and keep it horizontal, thus avoiding vibrations and
stress.
Allow a 30 cm (12 Inches) clearance around and above the key cutting
machine for correct functioning and maintenance.
3.3.2 Temperature and humidity
The tool should be used in rooms with a temperature range of 0 and 40
°C (273 K - 313 K) and a relative humidity lower than 50 - 60%.
3.3.3 Working environment
The machine must be used in a place protected from bad weather
(rain, hail, snow etc.).
994 LASER
If the machine is used in places exposed to corrosion,
maintenance shall be scheduled in such a way as to
prevent extreme wear of the components.
Do not use the machine in explosive or partially explo-
sive atmospheres or in the presence of inflammable
liquids of gases.
3.3.4 Lighting
In the place of installation lighting must be appropriate, in order to al-
low the correct use and maintenance of the machine.
3.4.0 Connections
3.4.1 Grounding
Key cutting machines 994 LASER have been designed in compli-
ance with the safety legislation in force and feature appropriate
safety devices to prevent work accidents. In particular the ma-
chine was built with materials that:
• are self-extinguishing;
• protect against electrocution.
The machine must be grounded through the centralized circuit of the
place of installation.
Warning:
Make sure that the main voltage is compatible with the
machine voltage.
Make sure that the active power outlets are grounded.
Do not touch the machine when your hands and/or feet
are wet or humid.
Avoid any contact with grounded plates.
Man. cod. B409619FG Copyright by Keyline - Italy