Descargar Imprimir esta página

Keyline 994 LASER Manual De Uso Y Mantenimiento página 52

Duplicadora eléctronica

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 105
9Maintenance, Dismantling and disposal
Warning:
IMPORTANT!
Before carrying out any maintenance operation you
must turn OFF the power and disconnect the power cord.
Maintenance must be carried out only by qualified per-
sonnel equipped with appropriate protective devices
for safe work.
Always use original Keyline spare parts.
9.1.0
General information
9.1.1
Skills of maintenance personnel
The machine operator must be knowledgeable about machine opera-
tion.
9.1.2
Type of Maintenance
Ordinary Maintenance
• Servicing operations that must be carried out periodically
by the machine operator.
• The purpose of ordinary maintenance is guarantee regular
functioning of the machine and a consistent quality of the
product.
• The maintenance schedule may vary in relation to work or
environmental conditions in the place of installation.
Complex Maintenance
• Complex maintenance consists of actions to be taken only
when given conditions occur (break downs, failures, re-
placement of parts).
• Due to the complex nature of such actions and the special
tools required, we recommend you should contact quali-
fied personnel from or authorized by Keyline S.p.A.
9.2.0
Ordinary maintenance
We recommend inspecting the machine periodically and replace worn
parts.
9.2.1
Checking and cleaning the fan
It is suggested to periodically check the cleaning level of the air grids
and make sure that there is no accumulated dust that could obstruct
the air passage.
18
Keyline S.p.A.
MAINTENANCE, DISMANTLING AND DISPOSAL
Poor ventilation could cause a machine overheating
and damage the components.
9.2.2
Cleaning the working area
At the end of each working day clean the machine removing scrap and
burrs to ensure proper functioning of the machine and to prevent any
damage to its parts.
Empty the shaving collection drawer every time that the work surface
is cleaned or whenever it is full of shavings.
Do not clean the machine with compressed air.
9.2.3
Cleaning the display
To clean the Touch Screen display we recommend using a micro-fibre
cloth; avoid using substances that contain alcohol or solvents.
9.2.4
Replacing the milling cutter
Spare part description
Code
Milling cutter 2,5mm
RIC03304B
Before carrying out this operation disconnect the pow-
er cable from the mains.
Required tools when replacing the milling cutter
• Patent pending.
• 1 T- Handle hexagon wrench (long) 3mm.
How to proceed:
• insert the bar to remove the cutter into the "Patent pend-
ing" seat;
• rotate the bar slowly until the bar 'tooth' fits into the slot
located inside the "Patent pending" seat;
• rotate the bar: the triangular mark on top of the bar will
point to the left;
• insert the T-shaped 3 mm hexagon wrench in the hole to
unlock the cutter (see picture in the next screen);
• loosen the nut that fastens the cutter;
• pull out the bar from the "patent pending" seat and remove
the cutter.
994 LASER
Frequency
When required
T- Handle hexagon wrench (long) 3mm
Man. cod. B409619FG
Triangular mark
Bar 'tooth' to
replace the cutter
Patent pending
Cutter calibration cut out
Copyright by Keyline - Italy

Publicidad

loading

Productos relacionados para Keyline 994 LASER