Publicidad
Idiomas disponibles
Idiomas disponibles
12
LONG END
MOLDING (Y)
ANGLE
BRACKET (QQ)
- Insert a LONG METAL PIN (PP) into the top edge of the RIGHT END (A). Only insert about 1/4 of the PIN into
the hole.
- Now, fasten the RIGHT END (A) to the DESK TOP (E) and MODESTY PANEL (L) as shown. Be sure the LONG
METAL PIN in the RIGHT END inserts into the hole in the DESK TOP. Tighten the TWIST-LOCK
in the RIGHT END and MODESTY PANEL.
NOTE:
Be sure the LONG END MOLDING (Y) on the RIGHT END is positioned toward the floor.
- Fasten an ANGLE BRACKET (QQ) to the RIGHT END (A) as shown. Use a 9/16" LARGE HEAD
SCREW (FFF) through the ANGLE BRACKET and into the pre- -drilled hole in the RIGHT END.
NOTE:
Be sure to position the ANGLE BRACKET as shown. Follow the diagram closely.
- Be sure the LONG END MOLDING (Y) is pushed all the way up against the DESK TOP (E), then fasten the
ANGLE BRACKET on the RIGHT END (A) to the LONG END MOLDING. Use a 9/16" LARGE HEAD
SCREW (FFF) through the ANGLE BRACKET and into the groove in the LONG END MOLDING.
NOTE:
The SCREW will tighten into the groove in the LONG END MOLDING. Do not overtighten
the SCREWS.
1736--100
MODESTY
PANEL (L)
RIGHT
END (A)
LONG
METAL
PIN (PP)
www.sauder.com/services
DESK
TOP (E)
9/16" LARGE HEAD SCREW (FFF)
(2 used in this step)
R
FASTENERS
Publicidad
