Sauder 1736-100 Instrucciones De Montaje página 35

15
The top edge of the
DRAWER FRONT
should overhang the
top of the drawer more.
DRAWER
FRONT (R)
PULL MOUNTS (VV) and
DRAWER PULL (UU)
7/8" LARGE HEAD SCREW (EEE)
(2 used for the DRAWER FRONT)
- Fasten the DRAWER FRONT (R) to one of the DRAWER BOX FRONTS (S2) as shown. Use two 7/8" LARGE
HEAD SCREWS (EEE) through the outer holes in the DRAWER BOX FRONT and into the DRAWER FRONT. Do
not overtighten the SCREWS.
- Fasten a RIGHT DRAWER SLIDE (DD) and LEFT DRAWER SLIDE (EE) to the DRAWER SIDES (T2) as
shown. Use two 1/2" FLAT HEAD SCREWS (GGG) through each SLIDE and into the pre- -drilled holes in the
DRAWER SIDES.
NOTE: The DRAWER SLIDES are marked "Drawer Right" and "Drawer Left" for easy identification.
Be sure the roller ends of the SLIDES are positioned toward the back edges of the drawer.
- Insert a PULL MOUNT (VV) into one of the holes in the DRAWER FRONT. Insert one end of the DRAWER
PULL (UU) into the hole in this PULL MOUNT. Insert the other end of the DRAWER PULL into the other PULL
MOUNT and insert it into the other hole in the DRAWER FRONT.
- Now, fasten the PULL MOUNTS with DRAWER PULL to the DRAWER FRONT. Use a 1- -1/4" MACHINE
SCREW (ZZ) through the DRAWER BOX FRONT, through the DRAWER FRONT, and into each PULL MOUNT.
LEFT
DRAWER
SLIDE (EE)
Roller
end
DRAWER
BOX FRONT (S2)
www.sauder.com/services
1/2" FLAT HEAD SCREW (GGG)
(4 used for the SLIDES)
DRAWER
SIDE (T2)
1- -1/4" MACHINE SCREW (ZZ)
(2 used for the PULL)
RIGHT
DRAWER
SLIDE (DD)
Roller
end
1736--100