Publicidad
Idiomas disponibles
Idiomas disponibles
18
The post should
insert into the
small hole in
front surface of
the DOOR.
DRAWER
1- -1/8" MACHINE SCREW (BBB)
(1 used for the PULL)
- Carefully stand your unit upright.
IMPORTANT:
Before fastening the DOOR to the END MOLDING, be sure the DOOR is spaced evenly
between the drawer and BASE (AA).
- To insert the drawer into your unit, tip the front of the drawer down and drop the rollers on the drawer behind the rollers
on the unit. Lift the front of the drawer up and slide it into the unit.
NOTE:
To adjust the DRAWER FRONT, loosen the SCREWS that attach the DRAWER FRONT to the
DRAWER BOX FRONT. Make adjustments and tighten the SCREWS.
- Fasten the DOOR (Q) to the END MOLDING (X) on the LEFT END (B) as shown. Use two 9/16" LARGE HEAD
SCREWS (FFF) through each HINGE and into the groove in the END MOLDING.
NOTE:
The SCREWS will tighten into the groove in the END MOLDING. Do not overtighten the
SCREWS. To make adjustments to the DOORS, loosen the SCREWS in the HINGES, make
needed adjustments, and tighten the SCREWS.
- Fasten a DOOR PULL (TT) to the front surface of the DOOR (Q). Use a 1- -1/8" MACHINE SCREW (BBB) through
the upper hole in the back side of the DOOR and into the PULL.
NOTE:
Be sure the post on back of the PULL inserts into the small hole in the DOOR.
1736--100
DOOR
PULL (TT)
LEFT
END (B)
DOOR (Q)
BASE (AA)
www.sauder.com/services
For assembly tips involving
this step, visit our web site
at: www.sauder.com/tips
END
MOLDING (X)
9/16" LARGE HEAD SCREW (FFF)
(4 used for the HINGES)
Publicidad
