Sauder 1736-100 Instrucciones De Montaje página 8

4
Slide the SHORT
END MOLDING (Z)
onto the notch.
SHORT END
MOLDING (Z)
HUTCH
LEFT
END (D)
- Slide a patented* SHORT END MOLDING (Z) onto the notch of the HUTCH RIGHT END (C) and HUTCH
LEFT END (D). Carefully slide both MOLDINGS until the MOLDINGS are against the HUTCH TOP MOLDING.
NOTE: The SHORT END MOLDINGS (Z) are shorter than all the other MOLDINGS.
NOTE: The MOLDINGS should overhang the surface with holes on the HUTCH LEFT END and
HUTCH RIGHT END. If the MOLDING overhangs the wrong surface, remove it and slide it on
again. Follow the enlarged diagram closely.
- Insert four METAL PINS (OO) into the ends of each PINNED UPRIGHT (K). Only insert about 1/4 of each PIN
into the holes.
- Now, insert the METAL PINS in one end of each PINNED UPRIGHT into the holes shown in the HUTCH
TOP (F). Follow the diagram closely.
* U.S. Pat. No. 5,499,886
1736--100
PINNED
UPRIGHT (K)
Finished
edge
These edges
should be even.
www.sauder.com/services
Insert two METAL
PINS (OO) into each
end of the PINNED
UPRIGHTS (K).
METAL
PIN (OO)
(8 used)
HUTCH
TOP (F)
SHORT END
MOLDING (Z)
Slide the SHORT
END MOLDING (Z)
onto the notch.
HUTCH
RIGHT
END (C)