Sauder 1736-100 Instrucciones De Montaje página 5

1
TWIST-LOCK R
FASTENER (JJ)
Read each step through completely before beginning the step. This box "-" is provided as a check- -off box. As you
complete each task, check it off.
- To begin assembly, push a SAUDER TWIST-LOCK
and LEFT END (B). Repeat this step for the HUTCH RIGHT END (C), HUTCH LEFT END (D), UPRIGHT (I),
HUTCH UPRIGHT (J), MODESTY PANEL (L), BOTTOM (M), and SMALL SHELF (N).
NOTE: Be sure the TWIST-LOCK
Make sure the point is positioned as shown in the enlarged diagram. Do not tighten the
TWIST-LOCK
NOTE: If you need to remove a TWIST-LOCK
of the hole. Pull at the front and back edges, slowly working the FASTENER out of the hole.
RIGHT
END (A)
R FASTENERS are positioned as shown in the enlarged diagrams.
R FASTENERS at this time.
www.sauder.com/services
Dowel end
LEFT
END (B)
For assembly tips involving
this step, visit our web site
at: www.sauder.com/tips
R FASTENER (JJ) into the large holes in the RIGHT END (A)
R
FASTENER from a hole, pull the FASTENER back out
Make sure this point
is in this location.
1736--100