Sauder 1736-100 Instrucciones De Montaje página 6

2
HUTCH TOP
MOLDING (V)
LARGE 1" FLAT HEAD SCREW (DDD)
(4 used in this step)
- Position the HUTCH TOP (F) as shown.
NOTE: Be sure the surface with holes on the HUTCH TOP is facing up. Be sure the unfinished edge of
the HUTCH TOP is facing as shown. Follow the diagram.
- Fasten the HUTCH TOP MOLDING (V) to the HUTCH TOP (F). Use four LARGE 1" FLAT HEAD
SCREWS (DDD) through the HUTCH TOP MOLDING and into the pre- -drilled holes in the HUTCH TOP.
NOTE: Be sure the finished surface of the HUTCH TOP MOLDING is facing up. Be sure the rounded
edge of the HUTCH TOP MOLDING is facing as shown. Follow the diagram.
1736--100
Finished
surface
HUTCH
TOP (F)
Rounded
edge
www.sauder.com/services
Surface
with holes
Unfinished
edge