Sauder 1736-100 Instrucciones De Montaje página 9

5
Surface with
TWIST-LOCK
FASTENERS
Long
finished
edge
Use the 1- -7/8"
FLAT HEAD
SCREWS here.
- Fasten the SMALL SHELF (N) to the HUTCH LEFT END (D) as shown. Also, be sure to insert the METAL PINS
on the PINNED UPRIGHTS into the holes in the SMALL SHELF. Tighten the TWIST-LOCK
HUTCH BOTTOM.
NOTE: Be sure the long finished edge of the SMALL SHELF is facing up. Be sure the surface of the
SMALL SHELF with TWIST-LOCK
diagram closely.
- Now, fasten the SMALL SHELF (N) to the HUTCH UPRIGHT (J). Use two 1- -7/8" FLAT HEAD
SCREWS (XX) through the holes in the SMALL SHELF and into the pre- -drilled holes in the bottom edge of the
HUTCH UPRIGHT.
- Fasten the DESK TOP (E) to the HUTCH RIGHT END (C) and HUTCH LEFT END (D) as shown. Use four
1- -7/8" FLAT HEAD SCREWS (XX) through the indicated holes in the DESK TOP and into the pre- -drilled holes in the
bottom edges of the HUTCH ENDS.
NOTE: Be sure the long finished edge of the DESK TOP is facing up. Be sure the unfinished surface
of the DESK TOP is facing away from the hutch. Follow the diagram.
SMALL
SHELF (N)
Long
finished
R
edge
HUTCH
LEFT
END (D)
DESK
TOP (E)
Unfinished
surface
R FASTENERS is facing as shown. Follow the
www.sauder.com/services
PINNED
UPRIGHT (K)
HUTCH
RIGHT
END (C)
1- -7/8" FLAT HEAD SCREW (XX)
(6 used in this step)
R
HUTCH
UPRIGHT (J)
FASTENERS in the
1736--100