Publicidad
Idiomas disponibles
Idiomas disponibles
14.2.2 Placing the timber into the device
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
Offset the vertical stop 1/2" to the right of the
horizontal stop.
• Ensure the vertical stop is square to the top of
the jig.
NOTE
If templates other than ½" are
used, this value must be adjusted
accordingly.
Mirror these settings on the right
hand side of the jig.
Align the timber so that the side of the
workpiece is mounted in the front vertical
clamp.
• It should extend above the front edge of the
jig by the thickness of the piece to be
mounted under the top clamp (front or back
of the drawer).
2. The piece of timber in the top clamp is
then butted up to this, so that both pieces are
flush under the template.
3. The two pieces sit in the jig as shown on
the right.
• Make sure that both pieces are putted up
against the horizontal / vertical stops.
4. Use the locking clamp handles to secure
the wood to the jig.
• You may need to adjust the top and front
clamp bars to suit the thickness of the
timber using the clamp adjusting screws at
either end of each clamp bar
so that the wood is held firmly in place
• When narrow pieces of wood are being
used, place another piece of wood (exactly
the same thickness) underneath the clamp
bar at the opposite end to ensure an even
grip on the wood and to avoid distorting
the bars
OPERATION
19
ZFS600
Publicidad
