Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
SAFETY WARNINGS
Before doing any maintenance work, disconnect the
electric power from the equipment and put on
suitable personal protective equipment (e.g. gloves,
etc.)
The user must carry out only routine maintenance
operations (understood as cleaning). In case of
extraordinary maintenance, contact a service centre
and request the intervention of an authorised
technician.
Damage caused by lack of or incorrect maintenance
(e.g. use of unsuitable detergents) is not covered by
the warranty.
To clean any component or accessory DO NOT use:
• Abrasive or powdered detergents
• Aggressive or corrosive detergents (e.g. hydrochloric/mu-
riatic or sulphuric acid, caustic soda, etc.). Attention! Do
not use these substances even to clean the floor under the
equipment
• Abrasive or sharp tools (e.g. abrasive sponges, scrapers, steel
brushes, etc.)
• Steam or pressure water jets.
On the first use wash the pans and the chamber with a cloth
damped with hot water and soap and end with rinsing and
drying.
CLEANING
CLEANING STEEL SURFACES
Usea cloth soaked in hot soapy water or specific
7
steel products (in this case follow the instructions
provided by the detergent manufacturer). Finish with
rinsing and drying.
CLEANING THE EQUIPMENT CELL
Clean the equipment cell daily to maintain high levels of
hygiene and equipment performance.
Use a cloth soaked in warm soapy water and finish with a rinse
and drying.
CLEANING THE CONTROL PANEL
Use a cloth slightly damped with a product specific
8
for crystals, following the instructions of the detergent
manufacturer.
Do not spray too much product to prevent infiltrations that can
damage the screen.
Rev. 0
6
7
The
image
is
indicative.
The
position of the
display may be
different
de-
pending on the
model
52
The image is indic-
ative.
It may change de-
pending
on
the
model
H
O
2
Publicidad
