Static Alignment Optimisation (With L.A.S.A.R. Posture) - Ottobock 7E10 Helix 3D Instrucciones De Uso

3.5 Static alignment optimisation (with L.A.S.A.R. Posture)

Preparing the prosthesis for alignment optimisation:
• Make sure that the Helix
• Remove the cable tie.
• Reintegrate the PU springs. Proceed in the reverse order as described in Section 3.8!
• Tighten the screws with the torques as defined in Section 3.7.
• Verify the length of the prosthesis on the patient.
38 | Ottobock
Load line
Hip Joint has been adjusted to the factory settings (also refer to Section 3.6).
3D
± 10 mm
2
30 mm
1
L.A.S.A.R.
Posture
Helix