Before Use - Dreame X40 Ultra Manual De Usuario

Before Use

1. Place the Base Station and Connect to an Electrical Outlet
Place the base station in a location that is as open as possible with a good
Wi-Fi signal. Remove any objects that are closer than 1.5 m from the front and
5 cm from either side of the base station. Insert the power cord into the base
station and plug it into the socket.
＞5 cm
＞1.5 m
Note:
· Make sure that no objects might block the signaling area.
· To prevent water stains from wetting wood floors or carpets, placing the
base station on tile floors or marble floors is recommended.
＞5 cm
I : ON
O : OFF
Firmly insert the power cord
upwards until the indicator turns
on.
2. Install the Ramp Extension Plate
3. Remove Robot Protections and Install the Mop Assembly
④
②
①
③
EN
11