Ambu aView 2 Advance Instrucciones De Uso página 21

Letters in grey circles
1. Closely examine the displaying unit and other parts for any damage. Do not use the
displaying unit if it is damaged in any way A .
2. Clean and disinfect the displaying unit (see chapter 9) L .
3. Select a secure and convenient location for the displaying unit. Then place the displaying
unit on a solid flat surface by folding out the stand located on the back side, or mount
the displaying unit on a pole using the pole mount supplied with the displaying unit
(see section 4.4) Ca .
4. Press the power button to turn the displaying unit ON and wait approximately
20 – 30 seconds while the displaying unit is starting up I .
5. If necessary, charge the displaying unit by connecting the power supply to a mains socket
and inserting the power plug into the power inlet on the back of the displaying unit.
The battery indicator shows a lightning icon
Note: Make sure the power supply is always present and functional. It is recommended to locate the nearest
power outlet before starting any procedure.
6. If necessary, connect the displaying unit to the Wi-Fi network (see section 5.1.).
7. Connect the Ambu visualization device to the displaying unit by plugging its connector
into the corresponding connector port on the displaying unit. Ensure that the arrows are
aligned and the colour matches on the connector and its port G .
Note: For preparing and operating the Ambu visualization device, please refer to the Instructions for Use for
the specific visualization device.
8. Verify that a live video image appears on the screen by pointing the distal end of the Ambu
visualization device towards an object, e.g. the palm of your hand. Ensure that the live
image has the correct orientation H .
9. If required, an external monitor can be connected to the HDMI or SDI port on the back of
the displaying unit (see section 2.3) F .
6.2. Setting up endoscope button configuration
The Administrator and the Service Technician can set up the endoscope button configuration, also
when the endoscope is not connected. All other users can view the current button configuration,
but not change it. The available functions depend on the type of the selected endoscope.
Configure the endoscope buttons:
• Press the Settings tab, then press
Endoscope buttons.
• Press the required endoscope
category 1 and select an
endoscope.
• The screen shows an overview of
the endoscope buttons with the
available functions.
• Press the required endoscope
button 2 , then select long or
short button press 3 .
• Press any action from the list to be
performed when the selected
button is pressed 4 .
• Repeat for each button.
The overview shows the selected
functions next to the buttons.
Note: Each endoscope type come
with a default button configuration.
Note: The changes made will be saved and apply for all visualization devices of the same type.
refer to the illustrations in the Quick Guide on page 2.
when the displaying unit is charging E .
1
3
4
2
21