Ambu aView 2 Advance Instrucciones De Uso página 35

12. Disposal
At the end of product life, clean and disinfect the displaying unit (see chapter 10). Before
disposing of the displaying unit, it is advised to delete all sensitive data (see section 9.4.).
Then, dispose the displaying unit in accordance with local guidelines for electrical and
electronic waste.
13. Technical product specifications
13.1. Standards applied
The displaying unit function conforms with:
• IEC 60601-1 Medical electrical equipment – Part 1: General requirements for basic safety and
essential performance.
• IEC 60601-1-2 Medical electrical equipment – Part 1-2: General requirements for safety –
Collateral standard: Electromagnetic compatibility - Requirements for test.
• IEC 60601-2-18 Medical electrical equipment – Part 2-18: Particular requirements for
the basic safety and essential performance of endoscopic equipment
The power supply conforms with:
• IEC 60601-1 Medical electrical equipment – Part 1: General requirements for basic safety and
essential performance.
13.2. Specifications for aView 2 Advance
Display
Resolution:
Orientation:
Display type:
Start up time:
Connections
2 x USB connection:
Digital video out:
Wi-Fi:
LAN:
Note: For 3G-SDI interface, it is recommended to use a quality cable with better shielding (e.g. RG6 grade).
Memory
SSD hard drive capacity:
Mounting interface
Mounting interface standard:
Electric power
Power requirement:
Battery type:
Battery Operation:
Protection against electric shock:
Note: For more information about battery time with different scopes connected, please contact your
local Ambu representative.
1920 x 1080 pixels
Landscape
12.8" colour TFT LCD
5 seconds
USB 3.0 Type A
HDMI and 3G-SDI (see note)
Video format: 1920 x 1080 p, 60 fps
Supports IEEE Standards 802.11ac/a/b/g/n
Ethernet RJ45 connector, 10/100/1000 Mbps
32 GB including Operating System
VESA MIS-D, 75 C, VESA FDMI compliant display,
Part D, with centre located mounting interface
19.0 VDC; 3.43 ADC
14.4 VDC 6500 mAh
Typical battery runtime of a new, fully charged
battery (the displaying unit turned ON and scope
connected) is 2.5 hours or more depending on the
connected scope (see note)
Internally powered
35