Coway APMS-1020A Manual Del Usuario página 16

ADJUST PARTICLE SENSOR
To adjust the particle sensor sensitivity
When you first turn on the purifier, the particle sensor is set to standard. You can adjust the sensitivity
as follows if the air quality LED stays at severe even after the purifier runs for 2 hours or more with
high pollution or if the air quality LED stays at clean even if the pollution is high.
1. Simultaneously press and hold the air volume button and mode button
for at least 2 seconds while the purifier is operating.
2. The currently set sensitivity is shown on the display.
* The default sensitivity is L1.
3. Press the air volume button to set sensor sensitivity as desired.
When sensor sensitivity is set, the following air volume indicators are
illuminated on the display.
Display
Sensitivity Level
4. Press and hold the air volume and mode buttons simultaneously for
at least 2 seconds again to input your selected sensitivity and return
to normal operation.
* If the air volume button and mode button are not pressed for 10 seconds after
selecting sensitivity, the selected sensitivity is automatically input.
15
L0/Air volume 1 L1/Air volume 2
Sensitive Standard
L2/Air volume 3
Insensitive
How to use
2 seconds 2 seconds
2 seconds 2 seconds