Waterco MultiCyclone 12 Manual De Instalación Y Funcionamiento página 13

MULTICYCLONE FILTER MAINTENANCE
The MultiCyclone filter maintenance is determined by the following conditions:
1. The sediment chamber is half filled with sediment. This accumulation of sediment can be
visibly monitored through the MultiCyclone clear sediment chamber. The MultiCyclone is
cleaned by simply opening the purge valve. Only 15 litres (4 gallons) of water is discharged
to clean the MultiCyclone of sediment.
Flush out the sediment chamber
With pump running:
While the water pump is running simply open the sediment purge valve until the sediment has
been flushed out. This is visible through the clear sediment chamber. Once the sediment has
been flushed out, close the purge valve.
Without pump running:
Alternatively, switch the pump, off. Open the air release valve and then open the purge valve.
The water will drop through the MultiCyclone flushing out most of the debris from the sediment
chamber. Then close the air release valve and turn on the pump and the turbulence of the
water entering the sediment chamber will flush out the rest of the sediment. Once the sediment
chamber has been cleansed, close the purge valve, start the pump and close the air release valve
once water is flowing out through the air release valve.
MultiCyclone I pg 09