Etac R82 Multi Frame Manual Del Usuario página 39

Safety
Signs, symbols and instructions placed on this product must never be covered or removed and must
remain present and clearly legible throughout the entire lifetime of the product. Immediately replace or
repair illegible or damaged signs, symbols and instructions. Contact your local dealer for instructions.
Any adverse event in relation to the device must be reported to your local dealer and the national com-
petent authority in a timely manner. The local dealer will forward information to manufacturer.
Caregiver
• Read the "User Guide" carefully before use
and keep it for future reference. Incorrect
use of this product may cause serious
injury to the user
• This product contains small parts which
could present a choking hazard if removed
from their intended placing
• Always use the correct lifting techniques
and aids for this purpose
• Never leave the user unattended in this
product. Ensure permanent supervision by
a caregiver
• Repair/replacements must only be made
using new original R82 spare parts and
fittings and carried out in accordance
with the guidelines and service intervals
prescribed by the supplier
• Be aware of any MAX mark indications
before adjustment
• Ensure that moving parts does not
squeeze or trap body parts when adjusting
them
• Ensure that body parts are not trapped
in openings for mounting of supports/
accessories.
• If there is any doubt as to the continued
safe use of your R82 product or if any
parts should fail, stop using the product
immediately and contact your local dealer
as soon as possible
• Always use the product in a moderate
pace. Do not run with the product
• Information regarding frame and seat
combinations including max. load in
combination can be found at: etac.com
• Information about transportation can
be found in the document "M1460
Transportation in Motor Vehicles" supplied
with the product
• Information about roadability can be found
in the document "Roadability" supplied
with the product
Environment
• Observe the surface temperature on the
product, before placing an user in it. This
goes especially for users with insensitive
skin as they cannot feel the heat. If the
surface temperature is above 41°C then
allow the product to cool before use
EN
User
• If the user is close to the max. load
limit and/or has a lot of involuntary
movements, e.g. rocking, a larger size
with a higher max. load or a different R82
product should be considered
Product
• Carry out all positional adjustments on the
product and accessories and ensure that
all knobs, screws and buckles are securely
fastened before use. Keep all tools out of
the reach of children
• Removable parts without use of tool:
wheels and foot support. The removal will
have adverse effect on the device
• Ensure the stability of the product is
maintained before placing the user in it
• Activate the brakes before placing the user
into the product
• Activate the anti-tips before angling the
seat and back
• Deactivate the anti-tips when forcing kerbs
higher than 100 mm
• We recommend you notify the user before
angling the seat and back
• Ensure the wheels are fully-functional and
secure before use
• The correct tyre pressure is printed on the
tyre casing and listed in the section for tyre
technical data.
• In case of a tyre puncture do not use the
product until remedied
• Unoccupied device is suitable for land and
air transport
• Attaching additional loads can adversely
affect stability. Position of points intended
to carry additional loads are specified in
the relevant Mounting Guide referred to
under section for accessories
• Do not expose the gas spring to pressure
or high temperatures. DO NOT puncture
• Inspect the product and all of its
accessories and replace any worn out
parts before use
• This product is tested for resistance to
ignition at level non-ignition in accordance
with EN 1021-1, EN 1021-2 and ISO
7176-16
• The product might lose its flame resistant
characteristics if using other than original
R82: Cushions
39
etac.com