Dreame X40 Ultra Manual Del Usuario página 14

Routine Maintenance
EN
Main Brush
1. Press the brush guard clips inwards to remove the brush guard and lift the
brush out of the robot.
2. Pull out the brush covers at both ends of the brush as shown in the figure.
Use the provided cleaning tool to remove any hair tangled in the brush.
Reinstall the brush covers on both ends of the brush, and then reinstall the
brush. Press on the brush guard to lock it in place.
22
Side Brush
Unscrew the side brush with a screwdriver, clean the hair from the brush, and
then screw it back on.
Routine Maintenance
Mop Pad Holder
Remove and clean the mop pad holder.
Omnidirectional Wheel
Note:
· Use a tool such as a small screwdriver to separate the axle and tire of the
omnidirectional wheel. Do not use excessive force.
· Rinse the omnidirectional wheel under the running water and put it back
after drying it completely.
Robot Sensors and Charging Contacts
Wipe sensors and charging contacts of the robot by using a soft and dry cloth,
as shown in the below figure:
Bumper Window
Laser Distance 3D Dual-Line Laser Sensors
Sensor (LDS)
Edge Sensor
Bumper
Charging Contacts
Cliff Sensors
Carpet Sensor
Note: A wet cloth can damage sensitive elements within the robot and the
base station. Please use a dry cloth for cleaning.
EN
23