Dreame X40 Ultra Manual Del Usuario página 10

How to Use
EN
Turn On/Off
Press and hold the button for 3 seconds to turn on the robot. The power
indicator should be illuminated. Place the robot onto the base station, the
robot should turn on automatically and begin charging. To turn off the robot,
move the robot away from the base station and press and hold the button
for 3 seconds.
Fast Mapping
After configuring the network for the first time, follow the instructions in the
app to quickly create a map. The robot will start mapping without cleaning.
When the robot returns to the base station, the mapping process has been
completed and the map will be saved automatically.
Pause/Sleep
When the robot is running, press any button to pause it. If the robot is paused
for more than 10 minutes, it automatically enters sleep mode. All indicators
on the robot will turn off. Press any button on the robot, or use the app to
wake up the robot.
Note: If the robot is paused and placed onto the base station, the current
cleaning process will end.
Auto Resume Cleaning
If the battery is too low, the robot will automatically return to the base station
to charge. After charging to the appropriate battery level, it will resume
unfinished cleaning tasks.
Note: To use this function, please enable it in the app.
14
Do Not Disturb (DND) Mode
When the robot is set to the Do Not Disturb (DND) mode, the robot will be
prevented from resuming cleaning and the power indicator goes out. The DND
mode is disabled by default at the factory. You can use the app to enable the
DND mode or modify the DND period. The DND period is 22:00-8:00 by default.
Note:
· The scheduled cleaning tasks will be performed as usual during the DND
period.
·
The robot will resume cleanup where it left off after the DND period expires.
Spot Cleaning
When the robot is on standby, press briefly the button to enable the spot
cleaning mode. In this mode, the robot cleans a square-shaped area of 1.5 ×
1.5 meters around it and returns to its starting point once the spot cleaning is
completed.
Robot Restarting
If the robot stops responding or cannot be turned off, press and hold the
button for 10 seconds to forcefully turn it off. Then, press and hold the
button for 3 seconds to turn the robot on.
How to Use
Vacuum and Mop
Note: When using the mop assembly for the first time, the robot performs the
"Vacuum and Mop" task by default.
1. Start cleaning
Press the button on the robot, or use the app to make the robot start from
the base station. Then the robot will plan the optimal cleaning route and
perform the cleaning task based on the created map.
Note:
· To ensure the robot easily returns to the base station after cleaning, it is
recommended to make the robot start from the base station.
· The mop pads will be cleaned before the robot starts mopping, please wait
patiently.
· Do not move the base station, the clean water tank, the used water tank, or
the washboard during operation.
· Hot water cleaning can be enabled in the app for mop pad and washboard
base cleaning tasks, which applies to all modes. To prevent scalding, do
not touch the water outlet when the function is on.
2. Auto mop washing
When cleaning, the robot will automatically return to the base station to wash
mop pads based on the mop pad cleaning frequency specified in the app.
The base station will automatically refill the robot's water tank and the robot
will resume cleanup.
EN
15