ECOVACS WINBOT W2 OMMNI Manual De Instrucciones página 15

Turn ON Station and WINBOT
2
Press and hold the Power button on the Station for at least 2 seconds
to turn on Station and WINBOT.
Before use, make sure Station has sufficient battery. If Station
battery is low, refer to the Charging
charging time is approximately 3 hours.
* If WINBOT is powered on but Fan is not working, WINBOT will shut
down after 10 minutes of inactivity. To resetart, press and hold the
Power button.
section. Under room temperature,
Fill up the Water Tank
3
It is recommended to use with ECOVACS WINBOT Cleaning Solution.
The maximum volume of the Water Tank is about 60 ml, and a full
tank can sustain spraying for about 60 minutes. In Fast Cleaning
mode, a full tank can cover an area of approximately 30 ㎡ .
Use ECOVACS WINBOT Cleaning Solution for better cleaning
performance.
* If ECOVACS WINBOT Cleaning Solution is used up, use tap water as a
temporary substitute.
To avoid product damage, do not use any cleaning solution other than the
dedicated ECOVACS WINBOT Cleaning Solution.
Do not use distilled water or filtered water.
Maximum: 60ml
15 EN