Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
This power tool generates an electromagnetic field
during operation. This field can impair active or pas-
sive medical implants under certain circumstances. In
order to prevent the risk of serious or deadly injuries,
we recommend that persons with medical implants
consult with their physician and the manufacturer of
the medical implant prior to operating the power tool.
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batter-
ies may only be charged with battery chargers of this
series. Observe the manufacturer's instructions.
WARNING
Follow the safety instructions and the
notes regarding charging and correct use,
as specified in the operating manual for
your 20V gomag series battery and battery
charger. A detailed description of the
charging process and further information
are provided in this separate manual.
6
Technical data
Cordless hand-held
circular saw
Motor voltage
Idle speed n
0
Weight (without battery)
Max. cut depth
at 90°
at 45°
Laser
Laser class
Laser wavelength (λ)
Max. laser power P
Saw blade
Dimensions
Tooth thickness / cut-
ting thickness
Size of hole
Number of teeth
Idle speed n max
Subject to technical changes!
30 | GB
GO-HKS165
20 V
4500 rpm
3.3 kg
approx. 54 mm
approx. 39 mm
650 mm
< 1 mW
Ø165 mm x Ø20 mm x 1.0 mm
1.6 mm
Ø20 mm
24 teeth
9200 rpm
www.scheppach.com
Noise and vibration
WARNING
Noise can have serious effects on your health. If the
machine noise exceeds 85 dB, please wear suitable
hearing protection for you and persons in the vicinity.
The noise and vibration values have been determined
in accordance with EN 62841-1.
Noise data
Sound pressure L
Measurement uncertainty K
Sound pressure L
Measurement uncertainty K
Vibration parameters
Vibration a
Sawing in wood
h
Handle
Measurement uncertainty K
Additional handle
Measurement uncertainty K
The total vibration emission values specified and the
device emissions values specified have been measured
in accordance with a standardised test procedure and
can be used for comparison of one electric tool with an-
other.
The total noise emission values specified and the total
vibration emission values specified can also be used for
an initial estimation of the load.
WARNING
The noise emission values and vibration
emission value can vary from the specified
values during the actual use of the power
tool, depending on the type and the manner
in which the electric tool is used, and in
particular the type of workpiece being pro-
2
cessed.
Try to keep the stress as low as possible. For exam-
ple: Limit working time. In doing so, all parts of the
operating cycle must be taken into account (such as
times in which the power tool is switched off or times
in which it is switched on, but is not running under a
load).
pA
pA
wA
wA
82.5 dB
3 dB
93.5 dB
3 dB
2
0.848 m/s
2
1.5 m/s
2
1.637 m/s
2
1.5 m/s
Publicidad
