8. Wear parts are generally excluded from the war-
ranty! - Wear parts are: a) supplied, attached and/
or installed batteries / rechargeable batteries as well
as b) all model-dependent wear parts (i.e. belts,
saw blades, tool attachments, grinding discs, filters,
carbon brushes etc., see operating manual). The
warranty does not cover batteries or rechargeable
batteries that are deeply discharged or those with
damaged housing or battery terminals.
9. Cost estimate - Products that are not covered or
no longer covered by the warranty will be repaired
at extra cost. Upon request to our service centre,
you can send in the defective products for a cost
estimate and, if necessary, give the service centre
approval for the repair in writing (by post, e-mail).
No further processing will take place without ap-
proval for the repair.
10. Claims other than those mentioned above cannot
be asserted.
The warranty conditions only apply in the current ver-
sion at the time of the complaint and, if necessary, can
be found on our homepage (www.scheppach.com).
In case of translations, the German version is decisive.
Scheppach GmbH · Günzburger Str. 69 · 89335 Ichen-
hausen (Germany)
Tel:
+800
4002
4002
vice.GB@scheppach.com
www.scheppach.com
We reserve the right to make changes to the warranty
conditions at any time without prior notice.
16 EU Declaration of Conformity
Original Declaration of Conformity
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
We declare under our sole responsibility that the prod-
uct described here complies with the applicable direc-
tives and standards.
Brand:
gomag
Item designation:
GO-HKS165 CORDLESS
HAND-HELD CIRCULAR SAW
Item No.
39018119982
EU directives:
2014/30/EU, 2006/42/EC, 2011/65/EU*
* The object of the declaration described above fulfils
the regulations of the directive 2011/65/EU of the Euro-
pean Parliament and Council from 8th June 2011, on
the restriction of the use of certain hazardous substanc-
es in electrical and electronic equipment.
·
E-Mail:
customerser-
·
Internet:
https://
www.scheppach.com
Applied standards:
EN 62841-1:2015/A11:2022; EN 62841-2-5:2014;
EN IEC 55014-1:2021; EN IEC 55014-2:2021
Documentation authorised representative:
Dawid Hudzik
Günzburger Str. 69
D-89335 Ichenhausen
Ichenhausen, 13.11.2023
Simon Schunk
Division Manager Product Center
Andreas Pecher
Head of Project Management
GB | 37