Bianchi E-OLTRE Manual Del Usuario página 11

SEAT POST CLAMP/EXPANDER
SPRINT
WARNING!
Use caution and observe the following warnings. Failure to comply with the warnings and provisions contained in this data sheet
exempts the manufacturer from any liability.
INFORMATION
If after loosening the M5 screw the seat post is still impossible to move, apply slight force on the saddle back and forth and, if neces-
sary, loosen the M5 screw again.
Use caution and observe the following warnings
INFORMATION!
For optimum grip and to eliminate slippage between the seat post and the frame, place a layer of gripper paste on the part of the
expander that is in contact with the seat post. (the gripper paste is included with the product).
DANGER!
Always comply with the torque levels specified on the seat post/expander clamp. Failure to comply with the recommended torque
levels may lead to malfunction and cause the rider to fall.
SEAT POST
The carbon fibre seat post provided is designed specifically for use with the Bianchi E-Oltre frame. Each frame size comes with a seat
post of the correct length and design to protect the integrity of the frame.
- 300 mm seat post > 47 cm / 50 cm frame
- 350 mm seat post > 53 cm / 55 cm / 57 cm / 59 cm / 61 cm frame
Always observe the maximum and minimum insertion limits.
The clamp/expander system provided is designed specifically for use with the
E-Oltre frame. Without this component, it is not possible to lock the seat post
in the desired position. To set the saddle height, loosen the M5 screws on the
seat post clamp.
Observe the torque indicated in the upper part of the clamp.
WARNING!
When adjusting the seat post never exceed the safety limit (MIN INSERT) indicated
on the component itself.
DANGER!
Exceeding the limit may cause the component to malfunction or break, causing the
rider to lose control and fall