Bianchi E-OLTRE Manual Del Usuario página 6

GEAR DROPOUT HANGER
The frame uses a Bianchi direct-mount dropout hanger. Special dropout hanger for
direct assembly that increases the rigidity of the rear derailleur while improving
gear change precision.
WHEEL THRU-AXLES
The front thru-axle is screwed directly onto the fork dropout using an M12 screw.
The solid axle integrated into the motor is screwed onto the frame using hexagonal nuts.
The axles provided are specific to this model and must be observed in order to be able to assemble the wheels safely.
WARNING!
Use caution and observe the following
warnings. Failure to comply with the
warnings and provisions contained in
this data sheet exempts the manu-
facturer from any liability.
DANGER!
The use of a thru-axle other than the one provided may result in the incorrect assembly of the wheel and may compromise the
integrity of the frame and fork.
WARNING!
Observe and use the thru-axles supplied with the product.
DANGER!
Do not mount the thru-axles to the frame or fork without the wheels, so as to avoid compromising the structural integrity.
DANGER!
Incorrectly mounted wheels may result in falls and serious accidents. If in doubt, contact your specialist retailer.
DANGER!
Never exceed the maximum torque value indicated. Incorrect tightening may damage the frame and fork.
BOTTOM BRACKET
Standard Press-Fit 86.5 x 41 mm bottom bracket.
The Mahle bottom bracket requires specific tools for maintenance; please contact your
specialist retailer.