Configuration Of The Adhesive Weight Application Position Selection - SICE S 65 Manual De Instrucciones

- Select the Enter button to confirm the measuring sensor position.
- Return the arm to the rest position.
If the calibration has been performed successfully, a consent message is displayed.
If the A20 message is displayed the measuring device position in the calibration phase is not
correct. Position it correctly, as described above, and repeat the procedure.
Select the Exit key to exit the programme without performing the calibration.
Service
This programme displays some data that are used to test machine operation and to detect the
malfunctioning of some devices. Since these data are not useful for the operator, it is recom-
mended that only technical support technicians consult them.
Select the service programmes icon to display this programme .
CONFIGURATION OF THE ADHESIVE
WEIGHT APPLICATION POSITION
SELECTION
The machine makes it possible for the operator to select where the adhesive weight
should be applied based on his needs.
UK
To select this configuration, proceed as described below:
- Select the "adhesive weight application position" icon .
- Three icons will appear on the display that represent the possible positions, as shown
below:
- Use the Enter button to select the desired position. The selected icon is
enabled if it is in the following configuration:
User manual S 65 109