Descargar Imprimir esta página

Polaris FREEDOM Plus Manual De Instalación Y Operación página 12

Robot limpiador inalámbrico

Publicidad

Idiomas disponibles

Idiomas disponibles

2.
Choose "Robotic Cleaner" from the list and
choose your model type.
3.
Follow on screen prompts to pair your cleaner.
4.
Slide the slider right and HOLD for ten
seconds to put the cleaner in Pairing Mode.
Wi-Fi LED Indicates Connection Status
BLINKING - pairing
SOLID - connected to internet
Figure 17. Slide and Hold Right to Pair
5.
Follow on-screen prompts to add your cleaner
and connect to your home router.
NOTE: If you have problems connecting, the Wi-Fi
signal may not be strong enough next to
the pool. Try placing the charging station in
another location closer to your home router
(see iAquaLink Troubleshooting section.)
Section 5. iAquaLink
IMPORTANT
WiFi signals cannot travel underwater. Most app functions are therefore
not available during a cleaning cycle. Place the cleaner back on the
charging stand to reconnect to the WiFi.
WARNING
Do not enter pool while the robotic cleaner is in water.
5.1
iAquaLink
Control Home Screen
®
App function and design is subject to change.
Page 12
Control
®
Polaris
FREEDOM
PLUS Cordless Robotic Cleaner | Owner's Manual
®
Start Cleaning
Clean Mode
Battery Charge Status
Green Charged: Fully Charged
Green Charging: Ready For Use
Orange Charging
Orange Partially Charged
5.2
Set Cleaning Mode
Start Cleaning
1.
From the main screen, select Cleaning Mode
to view options.
2.
Select Cleaning Mode. The factory default
cleaning mode is Floor/Wall.
3.
From the Home screen, press the Start button
to begin cycle. The cleaner will start when it
detects water and will cancel the cycle if not
submerged after 5 minutes.
NOTE: At the beginning of each cleaning cycle,
the robot confirms your pool parameters
(approximately 10 minutes). During this time,
the cleaner does not climb to the waterline.
Cleaning Mode
Floor/Wall
Product or App
Floor
Product or App
SMART
Waterline
SMART Cycle
SMART Cycle calculates a customized cleaning
time optimized for your pool. On the first run of
SMART Cycle, the app counts up as it calculates
the optimized cleaning time.
Select
Runtime
2.5 hrs
1.5 hrs
In App
Calculated
In App
0:45 min

Publicidad

loading

Este manual también es adecuado para:

FfreedompFrp550ctlr