Distilled water can extend the life of the
appliance.
• Use only demineralised or distilled water
(for Denmark).
• Never fill the boiler with solvents, liquids
that contain solvents or undiluted acids.
• Never immerse the product in any liquid.
If there is liquid on the device, unplug it
immediately.
• Only plug in the appliance when there is
water in the boiler.
• Make sure that the filling cap is firmly
closed before plugging in the appliance.
• Make sure that the device has no
pressurised steam before opening the
filling cap.
• Lock the trigger as soon as you have
finished steaming in order to avoid
unwanted steam emission.
• Risk of scalding due to excess water
discharge if the appliance is titled 45°
upwards or more than 90° downwards.
• Risk of scalding due to excess water
discharge if the appliance is excessively
shaken.
• Avoid contact with hot parts to prevent
burns.
• Never attempt to open the refill cap during
use. Once the appliance has completely
cooled down, carefully unscrew the refill
cap: the remaining pressurised steam
will start to escape after a few twists and
there is a risk of burns.
• Risk of burns! Allow the
appliance to cool down
for at least 30 minutes
before opening the refill cap.
• Injuries can result from misuse of the
product.
• The appliance is subject to residual heat
after use.
• Do not use with heat- or water-sensitive
materials. It is recommended to check
the use and care instructions from the
manufacturer.
• The product should not be used in areas
where there is a danger of explosions or
in the presence of toxic substances.
STORE THESE
INSTRUCTIONS CAREFULLY
• "This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation."
"No changes shall be made to the
equipment without the manufacturer's
permission as this may void the user's
authority to operate the equipment"
ISED: "This device contains licence-
exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and
Economic Development Canada's licence-
exempt RSS(s).
Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any
interference, including interference that
may cause undesired operation of the
device."
- 3 -