Descargar Imprimir esta página

VALBERG CNF 304 C WD X180C Instrucciones De Uso página 32

Publicidad

Idiomas disponibles

Idiomas disponibles

C
Cleaning and maintenance
Problem
The motor runs
continuously
A layer of frost
occurs in the
compartment
Temperature inside
is too warm
Temperature inside
is too cold
Doors can't be
closed easily
Water drips on the
floor
The light is not
working
Possible cause & Solution
It is normal to frequently hear the sound of the motor, it will
need to run more when in following circumstances:
• Temperature setting is set colder than necessary
• Large quantity of warm food has recently been stored within the
appliance.
• The temperature outside the appliance is too high.
• Doors are kept open too long or too often.
• After your installing the appliance or it has been switched off
for a long time.
• Check that the air outlets are not blocked by food and ensure
food is placed within the appliance to allow sufficient ventilation.
Ensure that door is fully closed. To remove the frost, please refer
to the "Cleaning and care" chapter.
• You may have left the doors open too long or too frequently; or
the doors are kept open by some obstacle; or the appliance is
located with insufficient clearance at the sides, back and top.
• Increase the temperature by following the "Display controls"
chapter.
• Check whether the top of the refrigerator is tilted back by
10-15mm to allow the doors to self close, or if something inside
is preventing the doors from closing.
• The water pan (located at the rear bottom of the cabinet) may
not be properly leveled, or the draining spout under neath the
top of the compressor depot may not be properly positioned to
direct water into this pan, or the water spout is blocked. You
may need to pull the refrigerator away from the wall to check
the pan and spout.
• Check if the refrigerator is power-off for a long time, this may
cause the ice in the bucket to melt into water, and flow to the floor.
• The LED light may be damaged. Refer to replace LED lights in
cleaning and care chapter.
• The control system has disabled the lights due to the door being
kept open too long, close and reopens the door to reactivate the
lights.
30
EN

Publicidad

loading

Este manual también es adecuado para:

987435