Pentair NOCCHI FP Multi EVO-A Manual De Instrucciones página 14

ENGLISH
servance of the current and relevant standards
and regulations.
Independent modifications and
the production of spare parts
Modifications to the machine are only admis-
sible on agreement with the manufacturer. The
use of original spare parts and accessories
authorised by the manufacturer will guarantee
safety. The manufacturer declines liability for
the use of non-original parts and any conse-
quences of such actions.
Improper use or operation
The operating safety of the machine purchased
is only guaranteed when used in compliance
with the instructions/information supplied. The
limit values stated in the chapter "Technical
Specifications" must never be exceeded, under
any circumstances.
Accident prevention instruc-
tions
Never perform work alone; always wear safe-
ty helmets and goggles, safety footwear and,
where necessary, suitable safety harnesses.
Before performing welding or using other elec-
trical devices, check that there is no risk of
explosion.
Take care to ensure cleanliness and good
health.
Ensure that there are no toxic gases present in
the work area.
Always observe safety standards at the work
place and keep a first aid kit on site.
In some cases, the pump and the pumping me-
dium may be hot and could cause burns.
For assembly in area subject to the risk of ex-
plosion, specific standards apply.
14 14
This device may be used by children over the
age of 8, or by persons with physical, senso-
rial or mental disabilities or those with little
experience or knowledge, if under supervision
or trained in the use of the device, and aware
of the associated risks. Never allow children to
play with this device. Cleaning and maintenance
required of the user may never be performed by
children without supervision.
The work required for electrical in-
stallations on the pump or control
panel must be performed exclusively
by a specialised electrician.
Ensure that the pump is only con-
nected to sockets installed in com-
pliance with current standards, made
safe by means of a high sensitivity
residual current circuit breaker (RCD,
30mA).
Before any operation on the pump,
disconnect the plug from the power
mains.
Check that the power cable is not me-
chanically or chemically damaged.
Replace any damaged or kinked ca-
bles.