Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Plan cleaning in advance:
11. Plan the cleaning route. Arrange long and straight runs with a minimum of stopping or starting.
12. Allow a small amount of broom path overlap to ensure complete coverage.
13. Avoid making sharp turns, bumping into posts, or scraping the side of the machine.
Filling the DustGuard™ system water tank (optional)
14. Remove the plug (29) to reach the filler neck.
15. Fill the tank (4) with clean water. Do not fill the tank completely, leave a few centimeters from the edge.
MAIN BROOM
Several different main brooms are available for this machine. To select the best broom for the surface and litter to be swept, contact
a Advance Retailer.
NOTE
To install the main broom, refer to Main Broom Maintenance paragraph.
OPERATING THE MACHINE
Proterra™ is a rider-type automatic floor sweeping machine. The controls were designed to be user friendly. For single pass
sweeping the operator can simply lower the main broom.
STARTING AND STOPPING THE MACHINE
Starting the machine
NOTE
The driver's seat (32) is equipped with a safety sensor, which allows the machine to be driven only when the operator is
on the driver's seat.
1.
Sit on the driver's seat (32), insert the ignition key (57) and turn it to "I", without pressing the drive pedal (37), then wait (for a
few seconds) for the charged battery warning light (51) to turn on.
If the red LED (51) turns on, turn the ignition key to "O", remove it and charge the batteries (see the procedure in Maintenance
chapter).
2.
Turn the ignition key (57) clockwise to "II", then release it when the main motor starts.
3.
Disengage the parking brake.
4.
Press the front side of the drive pedal (37) and drive the machine for 2 or 3 minutes at low speed to warm up the hydraulic
system.
5.
Drive the machine to the working area, by keeping the hands on the steering wheel (34).
6.
Press the front part of the drive pedal (37) to move forward and the rear part to move backward.
The drive speed can be adjusted from zero to maximum speed by increasing the pressure on the pedal.
WARNING!
When steering, avoid abrupt direction changes, pay careful attention and drive the machine at slow speed,
especially when the hopper is full or when operating on inclines.
Drive the machine slowly on inclines. Use the brake pedal (35) to control machine speed while descending
inclines.
Do not turn the machine on an incline; drive straight up or down.
Stopping the machine
7.
To stop the machine, release the pedal (37).
To stop the machine quickly, press also the brake pedal (36).
8.
In case of emergency, press the emergency push-button (21) to immediately stop the machine.
WARNING!
The emergency push-button (21) does not stop the machine. If it is pressed while moving, use the brake pedal
(36) to stop the machine.
9.
To reset the battery connector (40), open the battery compartment hood (1) using the release button (25) and connect the
battery connector (40).
10. Turn off the machine by turning the ignition key (57) to "O", then remove it.
11. Engage the parking brake.
16
INSTRUCTIONS FOR USE
Proterra™ - 33019867
revised 08/2018
09/2010
Publicidad
