VEVOR V-0.25/8 Manual Del Usuario página 11

- The piston being burnt-replace or repair
11. Outpout wind less
- The wind demanded larger than the wind specified-change a compressor with
larger HP
- The output pressure being large than the specified pressure-lower the operating
pressure
- The inlet tube being too small and too long-change to a bigger and shorter one
- The air cleaner being too small and too long-changer to a bigger and shorter one
- The valve assembly being damaged or not properly positioned-send to technical
shop to repair
- The packing being damaged-replace a new one
- The piston ring or the cylinder being worn out-replace a new one
- The triangle belt being loose-readjust it
- The unloading pin being unable to slip off-adjust it
- The discharge tube having leakage-replace a new one
12. The unload action being out of functioning
- The unloading valve holder being worn out at the top end or other parts being
damaged-replace or repair
- The unloading pipeline being blocked or having leakage remove and clean or
replace it
- The unloading valve stuck dead-remove and repair or replace it
13. The air tank pressure being too high or the safety valve whistling
- The output pressure being higher than the set pressure adjust to lower the
pressure
- The unloading system being damaged or out of work replace or repair it
- The unloading set pressure being too high-lower the set pressure
- The pressure gauge being damaged-replace or repair it
- The unloading air pipe line having leakage-repair or replace it
- The safety valve set pressure being too low or damaged adjust to heighten the
safety valve pressure or replace a new one
14. The valve assembly being worn or broken
- The valve assembly being dirty-remove and elean
- The pressure being too high-lower the operating pressure
- 10 -