Descargar Imprimir esta página

VEVOR V-0.25/8 Manual Del Usuario página 6

Compresor de aire a gas

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 81
Corp
b. Teresso 52 and 65 or Esstic 55 or 56 of American standard oil(ESSO).
c. D.T.E Oil 103 or 105 of MEIFG Company (Mobil). For compressor with small
hp can use SAE 30 lub for its substitution. But those with medium large hp, the
above revolving oil or oil with the same class is preferred,
2. Please keep the oil level in the red area on the oil gage. if oil kips used too
much, it will be not only waste much lub oil, but also allow carbon to stick to the
valve easily if oil is used too little,it will be burned or worn out easily for poor
lubrication, so, the oil level should always keep in the red area.
3. When oil becomes dark or polluted(using after some 500hours),replace it.
4. of cardboard or other utensil to guide out the polluted oil, inclining the
compressor forward until all the polluted oil is let out. Replace the oil plug tightly (it
is better to apply some stoppage glue or stoppage paste on the teeth of the oil plug
to avoid oil leaking). Open the oiling cover and fill in new oil until it reaches in the
middle of the red circular area.
5. Please don't fill new oil when the machine is running,
6. Forbid to use thick lub jkoil or wasted oil.
1. Check every part of the bolts and nuts to see whether they are loosen
2. Check to see whether the pipe lines are normal.
3. Check to see whether the pipe lines are normal.
4. Check to see whether clectric wires and electric switches are In accordan
ce with the prescribed rules and the wirconnections are correct.
5. Check to see whether each of the wheel foot support is packed firmly or level.
6. Check to see whether the belt pulley of th compressor can be easily turned by
band.
7. Before start,if there is compressed air in the tank,for preventing the motor from
over loading and burnt out, in model 1/4HP,the conter knob of the cylinder is first
turned to the place in the groove,so that it stars without loading.Then lift upon the
cotter knob and turn to place it on the upper edge of the groove and enter into the
NOTICES TAKEN IN OPERATION
- 5 -

Publicidad

loading

Este manual también es adecuado para:

V-0.25/8dW-0.9/8