Publicidad
Idiomas disponibles
Idiomas disponibles
horizontally forward slightly, and then rotate the ring
nut adjuster
to align with the arrow to adjust the
A
required position. The clutch handle in position 1 is
the farthest from the grip, and the clutch handle in
position 4 is the closest to the grip.
Right handle
① Start/stop switch
Turn the switch to "
" position:
The vehicle circuit is turned on,
and the engine can be started.
Turn the switch to "
" position:
The vehicle circuit is turned off,
and
the
engine
cannot
started.
Warning
Do not turn the switch from "
normal driving, as this may damage the engine or
exhaust system. Do not use the stop switch unless
in an emergency.
be
" to "
" during
16
② Hazard warning light button
Press the hazard warning light button, and the front
and rear turn signal lamps flash at the same time to
remind you of hazard.
③ Electric start button
Make sure that the engine start/stop switch is turned
to the "
" position, retract the side stand, shift the
transmission to the neutral position, press the
electric start button "
", and the electric motor runs
to start the engine.
Warning
If the engine does not start within 5 seconds, turn
the ignition switch to the "
10 seconds, wait for the battery voltage to recover,
and then start the engine again. If the vehicle does
not start after several attempts, contact the local
QJMOTOR service station to check the vehicle.
④ Throttle control grip
The throttle control grip is used to control the engine
speed. To accelerate, turn the handle in its own
direction and release to decelerate.
" (off) position, wait for
Publicidad
