Publicidad
Idiomas disponibles
Idiomas disponibles
(3) Screw in or out the adjusting screw ② to make
the free travel of the clutch meet the specified
requirements.
(4) Tighten the lock nut ①.
If the handle end of the clutch cable
cannot meet the requirements of the
free stroke after being adjusted to the
limit position, it can be adjusted by the
lock nut
and adjusting nut
A
cable and the engine end.
Engine idle speed adjustment
The motorcycle is equipped with a stepper motor
that automatically adjusts the idle speed to the
appropriate range. If adjustments are required,
contact your local QJMOTOR service station.
Throttle body
The idle speed of the motorcycle will be reduced due
to the pollution of the throttle body. It is better to
clean the throttle body every 5000km.
When cleaning the throttle body, disconnect the
negative electrode of the battery and the sensor
connector installed on the throttle valve; remove the
of the
B
33
throttle cable, the hose connected to the air filter and
the intake manifold, and remove the throttle body.
Spray the cleaning agent on the inner wall of the
throttle body, and brush off the dust and carbon
deposit with a brush.
After cleaning, reverse the operation, install the
throttle body, and ensure that all components are in
place, and try to start the engine successfully.
Notice
Do not allow impurities to block the bypas
Drive chain
The service life of the drive chain depends on proper
lubrication and adjustment. Improper maintenance
may cause premature wear of drive chain and
sprockets. In severe operating conditions, frequent
maintenance is necessary.
Publicidad
