Publicidad
Idiomas disponibles
Idiomas disponibles
reservoir is installed above the right handle of the
vehicle. If the liquid level is lower than the mark MIN
of the lower limit scale line of the fluid reservoir, the
specified brake fluid shall be added as appropriate;
The rear fluid reservoir is installed in the middle of
the right side of the vehicle. It shall be ensured that
the liquid level of the rear fluid reservoir is between
the MIN (or LOWER) and MAX (or UPPER) scales.
If the liquid level is lower than the MIN (or LOWER)
scale, the specified brake fluid shall be added.
Replenishing the brake fluid should be considered a
regular service necessity.
Caution
This vehicle uses DOT4 brake fluid. Do not use the
residual fluid from the cylinder opening and the
brake fluid left over from the last maintenance,
because the old fluid will absorb the moisture in the
air. Be careful not to splash the brake fluid on the
paintwork or plastic surface, it will eat away the
surface of these substances.
Brake system
The brake system to be checked daily is as follows:
(1) Check the brake fluid volume in the front and rear
brake fluid reservoir.
(2) Check the front and rear wheel brake system for
leakage.
(3) Whether the brake handle and brake pedal have
proper travel and are always connected reliably.
(4) Check the wear condition of the friction plate. If
the notch on the bottom line of the groove is
exceeded, replace the two friction discs together.
Warning
If the brake system or the friction plates require
service, we recommend that you take the work to a
service organization. They are fully equipped and
skilled to do the job in the safest and most econom-
ical way. When the new disc friction plate is just
replaced, the brake handle shall be grasped and
released for several times, so that the friction plate
can be fully extended to restore the normal handle
support force, and the brake fluid can be stably
circulated.
38
Publicidad
