Publicidad
Idiomas disponibles
Idiomas disponibles
engine.
Please connect the oil inlet and
return pipes as shown in the
figure.
The rated working pressure of
the fuel pump is 300kPa, and
the working current is < 2.2A.
The gasoline filter of the oil circuit of the vehicle is
integrated in the oil pump. Do not use the fuel pump
of other specifications, so as not to cause the fuel
injector stuck and the oil circuit problems.
Lubrication of parts
Proper lubrication is very important to maintain the
normal operation of every working part of your
motorcycle, prolong its service life and drive safely.
After driving for a long time or after the motorcycle is
wet by rain or washed, we recommend that you
lubricate the motorcycle. See the figure below for the
key points of specific lubrication and maintenance:
Lubricating oil for Motorcycle
Y
Lubricating grease
Z
① Rear brake pedal
shaft
Z
③ Shift lever pin shaft
⑤ Front brake handle
pin shaft
Z
Battery
The battery is located under the
driver's
seat
cushion.
battery equipped for this vehicle
is a valve-regulated wet-load
free battery. It is strictly prohibit-
ed to pry open the shell. There is
no need for fluid replacement
before and during use.
Read and observe the following precautions before
use:
1. Check the battery terminal voltage when it is
used for the first time. When the voltage is less
than the 12.6 V, it is necessary to charge: charge
voltage 14.4 ± 0.02 V, charge limit current 11.2 a,
charge until the current drops to 0.2 a (or refer to
the relevant parameters printed on the surface of
43
② Side stand joint and
spring hook
Z
④ Accelerator cable
Z
Y
⑥ Clutch handle
(pin shaft)
Y
The
Publicidad
