Yamaha 40 Manual De Instalación página 16

5. Adjust:
• Throttle cable joint position
Adjustment steps:
• Turn the throttle grip to the fully closed
position.
• Turn the magneto control lever 1 so that
its adjusting screw contacts the fully
retarding stopper a.
• Adjust the position of the cable joint until
its hole aligns with the set pin.
• Install the clip 2, and then tighten the
locknut 3.
WARNING
The cable joint must be screwed in a
minimum of 8.0 mm (0.31 in).
NOTE:
Put the "UP" b mark upward.
6. Check:
• Fully open position
Incorrect → Adjust.
Checking steps:
• Turn the shift lever to the forward position.
• Turn the throttle grip fully open.
• Check that the throttle valve lever so that it
contacts the fully opened stopper.
7
E