Attaching The Fan Blades; Installing The Light Kit To Switch Housing - Kichler 52 BASICS PRO SELECT Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ATTACHING THE FAN BLADES

CAUTION: Remove the rubber shipping blocks attached to the face of the motor. These
blocks keep the motor from shifting during shipping and MUST be removed during
installation.
Step 1. Attach the blade to the blade bracket using the screws and washers as shown in
Figure 14. Start screw into bracket. Repeat for the two remaining screws.
Step 2. Make sure the blade is straight and tighten each screw.
Step 3. Fasten blade assembly to motor using "Pre-Installed" mounting screws in the
blade bracket.
INSTALLING THE LIGHT KIT TO
SWITCH HOUSING
Step 1. Remove and discard the center plug from the switch housing.
Step 2. Attach the light kit to the switch housing by feeding the light kit wires (black and
white) through the hole of the switch housing and then screw it onto the switch housing
cover by nut & lock washer.
Step 3. Be sure it is tight enough to prevent light kit from vibrating loose (Fig. 15).
Step 4. Wire connect: White wire to white wire. Black wire to black wire.
Screws
Blade brackets
Fig. 14
White
White
Black
Nut
Black
Lock washer
Switch
housing
Light kit
Fig. 15
52" BASICS PRO SELECT | 13
Screws
Washers
Blades
Center
plug

Publicidad

Tabla de contenido
loading

Tabla de contenido