Fitting, Removing High-Pressure Hose; Connecting The Water Supply - Stihl RE 98 Manual De Instrucciones

English
Fitting, removing high-
pressure hose
High-pressure hose on machine
Fit
2
1
Push high-pressure hose onto the
N
connector (2)
Attach union nut (1) and screw it on
N
and tighten by hand
Remove
Unscrew the union nut (1)
N
Pull high-pressure hose off of
N
connector (2)
40
Connecting the high-pressure hose to
the spray
Fit
4
5
3
Push the connector (3) of the high-
N
pressure hose into the mount on the
spray gun (4) until it engages
Remove
Actuate the spring button (5) and
N
pull the high-pressure hose out of
the mount on the spray gun
High-pressure hose extension
As a rule, always use only one high-
pressure hose extension – see "Special
accessories"

Connecting the water supply

Connecting the water hose
N
Briefly rinse out the water hose before
connecting it to the machine to prevent
sand and other dirt particles from
entering the machine and to purge the
air from the water hose.
Diameter of water
hose: 1/2"
Length of water hose: min. 10 m (to
absorb pres-
sure surges)
max. 25 m
2
1
Push the coupling (1) on to the hose
N
connector (2)
Turn on water supply
N
To vent the system:
Actuate the spray gun (without
N
spray lance mounted) until a
uniform water jet emerges
RE 98