Console - Batavus C4 Manual Del Usuario

TELEMETRIC HEART RATE MEASUREMENT
This equipment has a built in pulse receiver, which
is Proatible with a telemetric Batavus C4 Check
pulse transmitter.
If you are fitted with a pacemaker, please
NOTE!
consult a physician before using a wireless heart
rate monitor.
If you want to measure your heart rate this way
during your workout, moisten the grooved
electrodes on the transmitter belt with water.
Fasten the transmitter just below the chest with the
elastic belt, firmly enough so that the electrodes
remain in contact with the skin while training, but
not so tight that normal breathing is prevented.
If you wear the transmitter and belt over a light
shirt, moisten the shirt slightly at the points where
the electrodes touch the shirt. The transmitter
automatically transmits the heart-rate reading to
the meter up to a distance of about 1 meter. The
heart-rate value is displayed in the meter. Follow
your heart rate during the training.
REMARKS ON TELEMETRIC MEASUREMENT
If the electrode surfaces are not moist, the heart
rate reading will not appear on the display. If the
electrodes are dry, they must be moistened again.
Allow the electrodes to warm up properly to
ensure accurate heart-rate measurement. If there
are several telemetric heart rate measurement
equipments next to each other, the distance
between them should be at least 1,5 m. Similarly,
if there is only one receiver and several transmitters
in use, only one person with a transmitter should
be within transmission range. The transmitter is
switched to an active state only when it is being
used for measurement. Sweat and other moisture
can, however, keep the transmitter in an active state
and waste battery energy. Therefore it is important
to dry the electrodes carefully after use. When
selecting training attire, please note that some
fibers used in clothes (e.g. polyester, polyamide)
create static electricity, which may prevent reliable
heart rate measurement.
Please note that a mobile phone, television and
other electrical appliances form an electro-magnetic
field around them, which will cause problems in
heart rate measurement.
O W N E R ' S M A N U A L

CONSOLE

BUTTONS
1. ENTER
Selects and confirms console functions
2. +/- BUTTONS
Adjusts resistance (Level) and selects the profile
3. BODYFAT
Begins measuring the body mass index and
bodyfat-%
4. RECOVERY
Calculates the fitness index
5. RESET
Resets set values
6. START/STOP
Starts, pauses, and stops training.During training,
pressing this button once activates the Pause mode.
Pressing the button again starts the program again.
FUNCTIONS
1. BODY MASS MEASUREMENT
The measurement is performed for users U1 -- U4
(not U0) based on the entered personal data. The
measurement requires you to use the hand pulse
sensors. Select your user position and enter your
personal data if you have not already done so.
a) Now press the Bodyfat button to start the
measurement and grip the hand pulse sensors on
G B
•
B A T AV U S C 4
7