Changing The Print Position; Setting The Print Pattern - Amano PIX-200 Manual De Instrucciones

2. When the "PAPEr button" display is blinking, insert a paper and
press (-) or (+) button to test print.
3. Press (E) button to end.
4. If you would like to return to the "set up program" display, press
(E) button at the "P4 End" display.
CAUTION: Touching the printing area while test printing may cause an
accident resulting in human injury.

Changing the Print Position

You can set the print position in two directions. One is to imprint on the left side of the paper, and
the other is to imprint on the right side of the paper.
(Factory default is set to Right)
1. Unlock and remove the cover.
Press (+) and (E) button at the same time for 2 seconds.
The "set up program" display will appear.
2. Press the (+) button three times to position the " " under THU.
3. Press (E) button and you will see "Prn PoSn right" blinking.
Press (-) or (+) button to change to "LEFt" .
4. Press (E) to confirm the setting, and you will go back to the "set up
program" display.

Setting the Print Pattern

In this setup, the Year digit, the print of Hyphen between month and date, the printing type of Hour,
the printing type of Minutes (Refer to page 26 "Diagram of Printing Type of Minutes"), kind of
Language, the preprogrammed comment, the type of Zero and the print of Leading Zero can be
set.
(At the "P1 Print yEAr" display, you can skip to the desired setting by pressing (+) or (-) button)
1. Unlock and remove the cover.
Press (+) and (E) button at the same time for 2 seconds.
The "set up program" display will appear.
2. Press the (+) button four times to position the " " under FRI.
11