Setting The Time Zone (Us Only) - Amano PIX-200 Manual De Instrucciones

(+) button 3 times to skip to "P4 CloC Sync" display.
4. Press (E) button to select official standard frequency or disable the
Atomic Clock. If you are in Europe, you can select from "GErAny"
(DCF in Germany), "britAN" (MSF in UK) or "oFF" (Disable the atomic
clock) by pressing (-) or (+) button. In case of other countries,
you can select either "on" or "off" by pressing (-) or (+) button.
5. Press (E) button to confirm your setting and you will return to "set up
program" display

Setting the Time Zone (US only)

This setup is for US only. In this setup, you can set the time zone or select to disable the Atomic
Clock function.
1. Unlock and remove the cover. Press (+) and (E) button at the same
time for 2 seconds. The "set up program" display will appear.
2. Press the (+) button eleven times to position the " " at the fifth
from the upper right corner.
3. Press (E) button and you will see "P1 LCd diSPly" display. Press
(+) button 3 times to skip to "P4 CloC Sync" display.
4. Press (E) button to set the time zone. When you set the time zone,
you need to input the time difference from UTC (Universal Time
Coordinated). Please refer to the following chart.
Time Difference from UTC Time Zone
-5
-6
-7
-8
5. When you see the "t ZonE" display where the hour is blinking, select
the time difference by pressing (-) button.
6. When you need to disable the Atomic Clock function because of
failure of radio signal receiving, interference, an inappropriate
location, or bad radio wave receiving conditions, please press (-)
or (+) button until you see "CLC SynC oFF". Press (E) button to
confirm your setting, and you will go to "P5 End" display.
7. Press (E) again to return to "set up program" display.
NOTE: If the unit is unable to receive radio signals, please move the unit
to another place where it can receive radio signals.
20
Major Cities
EST New York, Boston
CST Chicago, Houston
MST Phoenix, Denver
PST Los Angeles, San Francisco
:
: