Setting The Printing Length; Setting Of Printing Activation/Detecting Sensor - Amano PIX-200 Manual De Instrucciones

You can select from "r OFF", "C OFF", "L OFF" or "on" by pressing
(-) or (+) button. Please refer to the diagram below to select
what you need. Press (E) button to confirm your setting.
Code
Print the Leading 0
Disable 0 and print the number right aligned
Disable 0 and print the number centered
Disable 0 and print the number left aligned
Note: Leading Zero is applied to Number, Month, Date, Julian Date and Hour.

Setting the Printing Length

PIX-200 will automatically change the character font when you set the printing length. However, if
you have selected to use the Customized Comments, this function is not available. Input the
printing length by mm unit. If the value is smaller than the minimum length, you will see an error
message (Error 05) when putting the cover on. (The minimum length depends on the imprint format
you have chosen, and the maximum length is 35mm)
1. Unlock and remove the cover.
Press (+) and (E) button at the same time for 2 seconds.
The "set up program" display will appear.
2. Press the (+) button five times to position the " " under SAT.
3. Press (E) button and you will see "Pr LEnth" display where you
can set the printing length. You can select the length by
pressing (-) or (+) button.Press (E) button to confirm your setting.
4. When an error message (Error 5) appears on the display, change
the length and try again.

Setting of Printing Activation/Detecting Sensor

PIX-200 has two paper detecting sensor which enables to automatically print by simply inserting a
card or piece of paper. In this setup, you can select the printing activation as below and detecting
sensor method (Use the Center or Edge sensor, Use both sensor or Use the center sensor).
Mode Code
Automatic Auto
Manual button Will print by pressing the Print Button
Either Au btn Will print by pressing the Print Button or inserting a paper/time card
Meaning
Will automatically print by inserting a piece of paper/time card
Description
13