Setting The Number - Amano PIX-200 Manual De Instrucciones

1. Unlock and remove the cover.
Press (+) and (E) button at the same time for 2 seconds.
The "set up program" display will appear.
2. Press the (+) button six times to position the " " under SUN.
3. Press (E) button and you will see "P1 Print triger" display where
you can set the printing activation. Press (E) button and you can
select from "Auto", "button" or "Au btn" by pressing (-) or (+)
button. Press (E) button to confirm your setting.
4. When you see the "P2 PAPEr dEtEct" display, press the (E) button.
You can select from "C or E" (Use the center or edge sensor),
"CE Edg" (Use both sensor) or "CEntEr" (Use the center sensor)
by pressing (-) or (+) button.
5. Press (E) button to confirm your setting.
Press (E) again to return to the "set up program" display.
Note: The factory default is set to "Auto"(Automatic) for print activation
and "C or E" (Use the center or edge sensor) for detecting sensor.

Setting the Number

In this setup, you can select the starting number and the digits of printed number. Please make
sure that you have selected the imprint format which includes number (Refer to the "Imprint Format
Diagram" on page 8) or you have included "number" (Code No.19) when you have programmed the
customized comment. (Refer to the Diagram of character code on page 25)
1. Unlock and remove the cover.
Press (+) and (E) button at the same time for 2 seconds.
The "set up program" display will appear.
2. Press the (+) button seven times to position the " " at the upper
right corner.
3. Press (E) button and you will see "P1 Print nubEr" display where
you can set the starting number by pressing (E) button. Select
the number by pressing (-) or (+) button. To move to the next digit,
press (E) button. Press (E) button to confirm your setting.
4. You will see "P2 nubEr digit" display where you can set the digit
of the number by pressing (E) button. Select the digit of the number
by pressing (-) or (+) button. (The digit is available from 1 to 8) Press (E) button to confirm
your setting. Press (E) button again to return to "set up program" display.
14