Setting The Atomic Clock (Germany, Uk And Others) - Amano PIX-200 Manual De Instrucciones

2) Change the time by hand. (Please refer to page 6 "Setting the Time" or page 7 "Easy Way to
Set the Time)
Note:
When the "Completed Time Synchronization" mark is on, it means that the unit has received
the time code signal within 24 hours.
The clock may display the wrong time. This may happen if it fails to receive radio wave
signals properly because of interference, an inappropriate location, or bad radio wave
receiving conditions. Should this happen, move the clock to another place such as near a
window where it can receive radio wave signals.
Please face the ribbon carriage side of the unit to the direction of the radio wave signals.
Even if the clock is unable to receive radio wave signals, its Quartz mechanism will continue
to keep the time.
Inappropriate places to keep the unit
Please note that the clock may be unable to receive radio wave signals properly under the
following conditions.
- Inside a large building, between tall buildings, underground, building without windows.
- Close to overhead power lines, TV stations and train cables.
- Close to home electrical appliances or OA devices such as
TV's, PC's, refrigerators or fax machines.
- Close to furniture made of steel, such as steel desk.
- In places generating radio interference, such as near
construction sites, airports or in heavy traffic.
- Inside a vehicle, train or airplanes.
Setting the Atomic Clock
In this setup, you can select DCF in Germany, MSF in UK or disable the
Atomic Clock function. The factory default is set to DCF in Germany.
1. Unlock and remove the cover.
Press (+) and (E) button at the same time for 2 seconds.
The "set up program" display will appear.
2. Press the (+) button eleven times to position the " " at the fifth
from the upper right corner.
3. Press (E) button and you will see "P1 LCd diSPly" display. Press
(Germany, UK and others)
19